PS250 PSU cover with switch and two XT60 connectors

thingiverse

Cover allow you to have a IEC320 C14 250V with 10A fuse, rocker switch and led [power socket](https://aliexpress.ru/item/4000469723664.html?sku_id=10000001888865427) with two [Amass XT60 male connectors](https://aliexpress.ru/item/1005002140953815.html) for [PS250-H1V24](https://aliexpress.ru/item/32385221650.html) power supply unit (PSU). Original SLDPRT and STEP files attached. 1. Print the cover, XT60 fixer and Cap. 2. Solder the wires and install XT60 connectors to the cover from inside. Fix them in place with the printed fixer. <i>AWG18 is enough for 24V, 250W, but check characteristics for other PSU.</i> 3. Solder wires and install power inlet module to the cover from outside (there are latches, no screw needed). You can flip rocker switch if needed so zero is down for safety. <i>There is no need in such thick wires as I did, they will obstruct cover installation.</i> 4. Connect the cables to the PSU and fasten them. 5. Check with mutifuction-meter before use. 6. Install the cover and fasten with M3x20 bolt screw on the left and two M3x8 tapping screws on the right and right bottom. It is better to use countersunk screw from the bottom. <b>Note:</b> I haven't printed the most last version attached, where I corrected position and size of holes, height of left bottom cutout for bolt. I haven't tested the Cap. Hope it get printed well and you don't need to drill bolt hole more and install Cap on sealant as I did. Let me know if you print it and find small correction are needed. <i>If you find the model useful, please consider any [donate](https://yoomoney.ru/to/41001797201485).</i>