PS2 Slim 2 Vertical Stand

prusaprinters

<p>Vertical stand for the PS2 Slim 2 (SCPH-9000X). It's also compatible with the Slim 1 but wouldn't it be better to use <a href="https://www.thingiverse.com/thing:4822790">the correct one</a> for authenticity?</p> <p>The shape resembles the official design. However this is a vase design in order to cut down print time.</p> <p>There are two designs. One is single-piece open end, since no one is going to be looking at the back of the stand. The other has an end cap to close up the shape.</p> <p>Printing the main piece with either end facing down WITHOUT support is ok (I've accounted for the issue).</p> <p>End cap should be ok even if printed facing up if your enable support and the tolerance is dialed in fine. Otherwise, print with the flat exterior face facing down.</p> <p>Rubber feet of diameter up to 11mm are recommended for the grooves facing down towards the table and up towards the console.</p> <p>For side gripping, there are slots for you to fit some tape (either electric or automotive) as well as rubber feet (if you have those thin ones).</p> <p>This model also serves a torture test to check if you have Z axis/extrusion/vibration problems. You might find something you didn't notice before (hopefully not...)</p> Category: Video Games