PS2 Controller Port Sleeve Replacment

thingiverse

####This is a replacement part if your PS2 controller port sleeve broke off like mine did. ###Disclaimer: This part is not perfect! You may need to resize or sand off excess material to fit. ###Printing: This is a very small part with thin walls, so the the smaller the layer size, the better. Also put the infill at 100%, as this part is too small for anything lower. #####You can use PrusaSlicer's "variable layer height" to help speed up the print. ###After Printing: 1. Unless your sleeve broke off cleanly, I recommend breaking the pieces off and sanding them down individually as needed to fit. 2. Put on at a upper or downward angle for easy installation. 3. Lastly, when sliding it on be sure to have the flat bottom part go first. As the hole there is a bit wider on purpose.