PS Vita Charging Dock Stand (Recessed Logo)

cults3d

Remix of my other stand that had the logo protruding from the front. This one was crafted with Hatchbox wood PLA - I really adore this material. I took the PS Vita Stand by LordLeXaT and fine-tuned the front, introducing a different PS Vita emblem, then carved out a 2-stage groove down the center, adding a channel to run the cord. The lower portion of the hole is spacious enough for the USB tip to pass through, but only the upper half will accommodate the Playstation end of the cord, so it will sit high enough up for the dock to establish a connection. I utilized a brim to ensure flat corners but no additional support was required.