PS Vita Charging Dock Stand (Recessed Logo)

pinshape

Remix of my other stand that had the logo pushing out from the front. This one was made with Hatchbox wood PLA and I'm absolutely hooked on it, to be honest. I took the PS Vita Stand by LordLeXaT, gave it a thorough cleaning up front, added a fresh new PS Vita logo, then carved out a two-stage channel right down the center, and added a groove for the cord to run through. The bottom half of the hole is just large enough for that USB tip to fit snugly through, but only the top half will accommodate the Playstation end of the cord, so it'll sit high up enough for the dock to establish a connection with ease. I made use of a brim to ensure perfectly flat corners from the start, and it ended up not needing any other kind of support.