PS Vita Cartridge Holder

thingiverse

This is a basic cartridge holder for PlayStation Vita games. I drew inspiration from a Pez dispenser when designing this model. The holder part should be printed upright, and it will only require some supports in the logo etched on its side. The trays were printed without any supports but I used a brim to prevent warping. However, I had to trim a bit of plastic off the bottom to get it to fit properly. In hindsight, I would have avoided using a brim if possible. Additionally, the letters won't fit correctly if a brim is employed. The holder part took three hours to print, while each tray took one hour and the letters only required about three minutes at the Standard (.18mm layer height) setting with 100% infill.