PS Vita Cartridge Holder

cults3d

This is a basic game cartridge holder for the Playstation Vita console. I drew inspiration from a Pez dispenser when designing this model. The holder itself should be printed upright, requiring only minimal support material under the logo etched onto its side. Meanwhile, the trays can be printed without any supports, with a brim added to prevent warping during printing. Unfortunately, I had to trim off some of the excess plastic from the bottom to get it to fit properly. In retrospect, using a brim was probably unnecessary and would have been avoided if possible. The letters didn't fit well when printed with a brim either. The holder itself took three hours to print, while each tray required an hour and the letters only needed about three minutes at standard layer settings (.18mm). All parts were printed with 100% infill density.