PS Vita Cartridge Holder

pinshape

I designed this simple cartridge holder for Playstation Vita games with a unique twist - its design is inspired by a Pez dispenser. The holder part should be printed vertically, requiring only minimal supports in the logo etched on the side. In contrast, the trays can be printed without any supports at all, but I did use a brim to prevent warping. To get a snug fit, I had to shave off a bit of plastic from the bottom. If possible, it's best to avoid using a brim altogether, as it won't accommodate the letters. Printing at Standard (.18mm layer height) setting with 100% infill, the holder part took three hours to complete, while each tray took one hour, and the letters just three minutes.