Práctica 6

thingiverse

Welcome to Module Two of Practices! If you're reading this, we assume that you've familiarized yourself with the concepts of Layer Height, Bottom/Top Thickness, Fil Density, and Print Speed - if not, we recommend giving the previous module a look where we explained these concepts in detail. Practic 6: Retraction File to print: Aniversary Roses Cura Settings: Layer Height: 0.20mm Bottom/Top Thickness (mm): 0.8mm Fil Density: 40% Print Speed (mm/s): 40mm/s Extruder Temperature: 190°C PLA / 210°C ABS (this temperature is a rough guide, follow manufacturer instructions for filament) Bed Hotend Temperature: 60°C PLA/100°C ABS (spray printing surface with lacquer before printing, also use Nely brand lacquer) Support: Support Type: None Platform Adhesion Type: None Filament Diameter: 1.75mm or 3mm depending on the filament diameter your printer uses Flow Rate: 100% Enable Fan Layer: Active Retraction Settings: Speed: 40mm/s (retraction speed, keep it similar to this setting but adjust if necessary) Distance: Measured in mm, with a distance of 0, the retraction will be disabled - any number above zero means the amount of filament the printer will retract while changing between printing points.