Prusa standoff bed level

prusaprinters

<p>This is the remix version from Thingverse by shrop_pat.<br/> <a href="https://www.thingiverse.com/thing:4335944">https://www.thingiverse.com/thing:4335944</a></p> <p>This version cut down the height of the standoff to 3.9mm. so you will be able to use the calibration-z function on stock firmware.</p> <p>This is an alternate way to level the bed on a Prusa MK3(S).<br/> This method uses M3 threaded brass pillars which are height adjusted using convenient thumb wheels.</p> <p>The wheels prints with no supports.</p> <p>You will need<br/> 9 pcs. M3X5mm+6 brass standoff<br/> 8 pcs. very thin washers.</p> <h3>Print instructions</h3><p>Recommended print this in PETG with a 0.2mm layer height.<br/> 35% fill density, 4 Perimeters.<br/> No supports required.</p>