Prusa MMU2 PFTE tubes organizer v2

thingiverse

I'm Version 2 with middle support also, featuring a new tube bar organizer that can now accommodate an additional set of tubes in the middle. This is my take on the PFTE tube organizer for the MMU2. I've designed it to be versatile and easy to assemble. To get started, you'll need to print two of each tube separator. This will give you a total of four pieces that are 3mm x 10 mm in size, along with four 3mm nuts. If you want to add an extra layer of support by installing the mid bar between two sets, you'll need to swap out the mid screws for ones that are 3mm x 12 mm in length. This will cause the two sets to angle at a 135-degree mark.