Prusa MK3 Y-Rod holder (uses original hardware)

prusaprinters

<p>(- Update - 5. 6. 2019 - y-rod_holder_part_2_for_2-3mm_thick_nut.stl has been added for square nuts with thickness of 2.3mm)</p> <p>(- Update - 21. 5. 2019 - y-rod_holder_part_1 has been updated with lower brace that inserts into the aluminum extrusion T-slot)</p> <p>(- Update - 17. 5. 2019 - Better spacing between part 2 and the Y-carriage, Square nut slides into Part 2 a bit better force is still needed for a snug fit)</p> <p>Print using 9 Perimeters.<br/> Use supports from bed only</p> <p>This Y-Rod holder clamps the rods securely and uses the same hardware as the original mk3 Y-Rod holder.</p> <p>--Assembly--<br/> -The square nut slides into Part 2 will require a little bit of force.</p> <p>-(IMPORTANT STEP - Snap part 1 and 2 together and screw it tight to seat the nut proper)</p> <p>-You will need to squeeze the sides when screwing to the frame</p> <h3>Print instructions</h3><p>Print using 9 Perimeters.<br/> Use supports from bed only</p> <p>--Assembly--<br/> -The square nut slides into Part 2 will require a little bit of force.</p> <p>-(IMPORTANT STEP - Snap part 1 and 2 together and screw it tight to seat the nut proper)</p> <p>-You will need to squeeze the sides when screwing to the frame</p>