Prusa MK3 PiCam mount with X motor cable clamp

thingiverse

I really loved the two designs linked below, but they wouldn't work together at first glance. However, yes, they will! Introducing the PIcamcableclamp :) This is a remix/combination of two things: The main support arm comes from: https://www.thingiverse.com/thing:2956323 and the cable clamp is from: https://www.thingiverse.com/thing:2887361 I made one change to either design, adding chamfers along the underside of the cable clamp arm. Originally, it was fine in its original orientation, but in this orientation, it fell short of 45 degrees and drew attention from the support generator. I trimmed the corners to reach 45 degrees. The remaining parts can be grabbed from their respective original thing (cable clamp end, camera case, etc). [Edit] I added cable clips to keep the unruly ribbon cable in check. The 11mm clip goes on the fattest part of the arm, while the 7mm clip goes on the thinnest. [Update: 29Dec2018] After performing some overdue maintenance, I discovered that once the necessary X-Belt adjustments had been made, the arm would no longer mount to the motor (due to the adjusted motor being rotated differently than before). The V2 updated version trims two mm from the top of the motor mount.