PRUSA MK3 Frame Brace

thingiverse

*** EDIT 2/26/2019 ***: Added a Raspberry Pi mount remixed from https://www.thingiverse.com/thing:2334119 by hackaholic to the top mount. *** EDIT 8/30/2018 ***: I finally got around to adding this to my newer machine and found the upper mounting holes have been moved. They are 5.5mm higher on my newer machine, so I'm adding a second, longer bottom. Measure down to the outermost tapped hole from the frame top. If it's approximately 74mm, use the long lower mount. MK3 Frame brace for the Einsey side. Connect the 3030 rear extrusion to existing M3 Threaded holes in the upper frame. (If you haven't used them for another purpose) Print 2 each of the Spacer and nuts. Not required but this is designed to 3D print with plastic, so 2 will make it much stronger. I modified the Extrusion nuts from https://www.thingiverse.com/thing:2805753 by JLTX and made them turn 90 degrees clockwise and stop. You'll need: (2) M3 x 20mm Screws (For the center of the spacers. Any head style except countersinks as long as they fit in the clearance holes.) (4) M3 x 10mm Screws (Same as comes with the kit or similar. These attach the top and bottom brace parts together and the top to the frame. Do not use a screw that will protrude to the front side of the frame.) (4) M3 Nuts (I prefer lock nuts. 2 go in the extrusion nuts, and 2 for connecting the top and bottom together.) (4-8) Flat head Screws (Attaching the brace to the spacers. I find drywall or wood screws hold very well in the plastic. There are 4 holes for each spacer but not necessary.) I also used super glue for the joint when connecting the top and bottom braces together. The only reason the joint is there was to be able to fit the MK3 print bed. If you use two spacers, you can fix one to the brace and only have to attach the second after aligning the brace at the top. Set the spacer in place on the extrusion so there's no gap at the top mount to the frame! You don't want to pull this joint together with the screws and twist the frame. I may edit to be able to add a metal plate to the brace in the future for those with the ability if popular enough.