Prusa MK3 Case for SKR 1.3

thingiverse

Based on the original electronics case from the Original Prusa MK3, a version has been designed specifically for my Prusa Clone that fits the SKR 1.3. The original case can be found here: https://github.com/prusa3d/Original-Prusa-i3/tree/MK3/Printed-Parts/stl. This custom case uses the same mounting points and cable clips as the original, but with a few key modifications. I recently upgraded to the SKR Board after receiving my new Hemera Extruder, and took advantage of this opportunity to switch to Marlin 2.0. In addition to these changes, the custom case includes provisions for mounting a 40mm fan that blows directly onto the driver chips, as well as an extra 60x60mm mounting pattern for a mosfet board used to control the printer's 5V fans. This mosfet board can be purchased from Amazon at: https://www.amazon.com/Channel-MOSFET-Button-IRF540-Arduino/dp/B01N5VRZWF. Hardware: Mounting Screws to the frame are identical to those used in the original case. 4x M3x8mm screws for mounting the SKR board 4x M3 Hexnuts 1x M3x20mm screw to close the case For extra fan & board: 4x M3x8mm screws for the mosfet board 4x M3 hexnuts 4x mounting screws for the fan Installation: The easiest way to install this custom case is to connect all cables while the board is still outside of the case. Next, attach the case to the printer frame and then mount the board to the case. Finally, secure the door to the frame.