Prusa-Mini X Carriage for E3D Bowden

thingiverse

Prusa-Mini X Carriage with Integrated E3D Mount for Bowden Setup - Stock Prusa Mini X Carriage that Includes an Integrated E3D Mount. PLEASE NOTE: The Upper Bearing tube may need to be resized slightly depending on the Print, as mine was a little tight with PETG. My Prusa Mini build started out as a fun project using some extra parts I had lying around from an i3 clone while waiting for my actual Prusa Mini order to ship in the spring. I already had typical 220x220 heat-beds and build surfaces, lots of 300 and 320mm guide rods, and NEMA 17 steppers on hand. I also had a few E3D V6 clones, so I ordered a SKR Mini E3 board and 3.5 Touchscreen display to get started remixing parts to put something together. I needed to order the 10mm guide rods and bearings, but it's coming along nicely now. As of 02/22/2020, I just need to finish adjusting the firmware file for this configuration and set up the touchscreen in Portrait Mode to fit this form factor. What I've ended up with is a 220mm cube build volume printer (similar to an original i3 or Ender 3 but in a much smaller frame). We'll see how well it works, but a bowden fed V6 and TMC2209 steppers can't be too bad!