Prusa Mini USB Holder for Ikea Skadis

prusaprinters

<p>Designed this USB holder for the USB-drive that comes with the Original Prusa Mini, but it should fit other small USB-drives as well.</p> <p>Made to fit on the Skadis organizing wall from Ikea.</p> <h3>Print instructions</h3><p>Printed it at 0.2mm layers <strong>with the top facing down</strong>, but it should work just fine as-is if you enable supports.</p> <p>Bed adhesion is very important since it is a small part, so <strong>a brim might also be needed!</strong></p> <p>USB-drive might not slide in smoothly if you go over 0.2mm layer height, although I have not tested that.</p>