Prusa Mini Raspberry Pi Camera Mount

thingiverse

A camera mount for the Prusa Mini. If you're using OctoPrint or another software with a camera to monitor your 3D prints, this mount is perfect for you. It attaches over the stepper motor on the Y axis. To complete this project, all you'll need in addition to the printed parts are M3 nuts and bolts (make sure they're long enough). I've also added a NeoPixel 12 LED ring camera mount that works with OctoPrint and the Status LED plugin. To install it, I soldered four angled pins onto the ring and glued it firmly to the mount using superglue. The wiring setup is as follows: Connect USB ground to the black wire on the NeoPixel ring. Link USB VCC to the red wire powering the NeoPixel ring. Route Pin 10 (or any pin you use with the Status LED plugin) directly to the DI (digital in) on the NeoPixel ring using the yellow wire.