Prusa Mini display box with Raspberry Pi Zero 2 mount

thingiverse

The Raspberry Pi Zero2 is such capable yet small machine that fits perfectly with Mini. So I modified the display box file and added this side mount for the pi zero. No support needed. Ideally one should use the w version without the GPIO pin soldered. It should be also possible to change the orientation and moun the wh version, although not recommended. At least two M2.5 screws are needed for mounting. I only have M2.5x8mm so I added in a case that I printed before for extra padding. It is the Clipping case from PierreNick (https://www.prusaprinters.org/prints/86855-raspberry-pi-zero-2-w-clipping-case-for-prusa/comments) in case you wonder. Due to the geometry it is not easy to screw the two M2.5 close to screen. You can just omit them (as in the pic), and the mounting should still be really firm. There is also the possibility to add the camera cable. Ideally this should be compatible with This Camera Mount by TinkrMakr (https://www.prusaprinters.org/prints/46427-prusa-mini-mini-raspberry-pi-camera-module-v21-8mp). However, you need longer cables (30cm) for connecting to the camera, otherwise disconnection will happen when Z position is too high. The common 15cm cable will not work for all Z range. There is another version with camera mount available.