Prusa LACK enclosure PSU (cable) passthrough

thingiverse

This add-on for the Prusa LACK enclosure lets you mount the PSU outside the enclosure. I used to have the v1 enclosure, which allowed me to remove the entire top whenever I needed to pull the printer out for maintenance, and it wasn't hard to take the PSU with it too. The new v2 enclosure assumes that every time you remove the printer from the enclosure, you must disconnect the PSU cables first. I didn't want to do that, so I came up with a solution. To make this work, I cut out a section at the back of the table top, large enough for the entire PSU to fit through. You can just print the "cable hole liner" part and use it as a guide to get the right size. This design includes two parts: The first one is called "cable hole liner." It fits snugly into the hole in the table to finish it off and keep the cables from getting worn out by constantly rubbing against the inside of the table. The second part is called "cable hole lid." It covers the hole while you're using the printer, leaving just a small opening for the cables to pass through.