Prusa Lack Enclosure Power Supply 3/4" hole Upgrade

thingiverse

This upgrade addresses a problem I encountered with the Prusa Lack enclosure's original part, which consistently pinched power supply cords. Inspired by the filament hole, I designed this modified piece for the bottom to guide power supply cords into place, reducing the likelihood of pinching. You can also customize it to accommodate other holes for wiring within your enclosure if desired. Please note that before drilling a hole, examine the area first to ensure it won't interfere with the power supply sitting at the bottom. I made this mistake initially but managed to makeshift the power supply by using screws to fit it further back. To complete this upgrade, you'll need a 3/4-inch drill bit. Additionally, consider scaling down the model slightly as it was quite a tight fit; I was able to insert it with a rubber mallet.