Prusa I3 MK3 side plate

myminifactory

This plate is an excellent addition to any Prusa I3 MK3, adding a practical and visually appealing touch. The tray consists of four distinct sections: the SD Card Holder, the Smooth Tray, the Rough Tray, and the Screwdriver Holder. The SD Card Holder securely holds three SD Cards in place for easy access later. The Smooth Tray is ideal for storing small items that are scattered around. In contrast, the Rough Tray features built-in bumps on its bottom to prevent screws or nails from rolling away. Two small holes on the side of the tray serve as a convenient holder for screwdrivers and hex wrenches. To assemble and install the tray, follow these basic steps: Place an M3x15 screw into the hole at the bottom of the tray piece. Next, position the latch piece over the partially driven screw in the main tray piece and drive it almost all the way through both pieces. Remove the two diagonal screws from the left Prusa Z motor. Rotate the latch piece 45 degrees to the right and slide the tray clip onto the motor while rotating it back to its original angle after it is placed over the two screw holes. Finally, replace the screws in the diagonal screw holes through the new piece.