Prusa i3 Mk3/S+ Power Supply Holder - Straight Side

prusaprinters

This is an ultra-simple remix of the Prusa i3 Mk3/S+ Netzteil Halter power supply holder by Fe_ix. Instead of the screw-points being along the same plane, I made one of them continue straight on so that you can screw one side into the side of the Lack enclosure, and the other point into the bottom.I had several issues with the standard Lack configuration involving a single screw being the only thing keeping the far end of the power supply held to the bottom of the surface, so I looked for something to support it better, found Fe_ix's design, and made a quick mod. Have to say, it works wonderfully! There's a little bit of wiggle; this holder isn't tight to the PSU, but it certainly does the trick.Printed with Prusament black PETG with default infills and 0.3mm layer height/draft setting because it's such a simple object.