Prusa I3 MK3 OctoPrint Raspberry Pi 4 Einsy Case

thingiverse

I took pictures with this sitting on my mini, but printed them on my Ender 3. :D EDIT 03-10-2020: I just added the Pi cover part because I realized that I extended the face of the Pi case by 1.8mm and didn't change the cover to match. It's a small detail that would annoy me. I remixed the RPi 3+ case by lab27 to house an Rpi 4, as RPi 3s are hard to come by now. It's a tight fit, but I prefer it that way. My test print is shown in the pictures. Post a comment if you're having trouble fitting the Pi and I can make some adjustments. I found that holding the Pi at an angle so that the USB connectors protrude slightly, as shown in the pictures, then rotating it into place works well. I'm not sure what size screws the original design was intended to use, but I used the same size holes. I may change this to better fit an M2 or an M2.5 or a thread-forming screw. Suggestions are welcome. Here's lab27's thing: https://www.thingiverse.com/thing:3127643 You can print the remaining parts from lab27's files. Enjoy!