Prusa i3 MK3 Filament Filter

prusaprinters

<p>This filament filter is (to no ones surprise) heavily influensed by the great filament filter by CNC Kitchen, for the <a href="https://www.amazon.com/3D-Printer-Prusa/s?k=3D+Printer+Prusa&amp;linkCode=ll2&amp;tag=thingiverse09-20&amp;linkId=28c787aef7c5a20cf2004b821dd161bf&amp;language=en_US&amp;ref_=as_li_ss_tl">Prusa</a> MK2S.</p><p>Put a small square piece of foam in the compartment, push through a pointy piece of filament several times to form a hole, snap it into place on top of the extruder and off you go.</p><p>&nbsp;</p><p>&nbsp;</p><p>-Make sure the holes are clear after printing.</p><p>-Don't jam too much foam into the compartment. Otherwise the foam will grab or stick to the filament.</p><p>-Probably not a good idea to use with the filament sensors runout feature, since the filament that it pushes back up again most likely will get stuck in the foam.</p><p>-Start with putting the bottom end into the hexagonal hole, and then "lifting" it into place on top.</p>