Prusa i3 heated build platform cable strain relief clip

thingiverse

Published on December 22, 2013, ctheroux released an upgraded version of this component at http://www.thingiverse.com/thing:204666. This clip serves as a secure anchoring point for the power and sensor cables of the heated build platform on a Prusa i3 printer. The elevated section fits over the rear bar of the Y plate and is held in place using one or more 100mm cable ties. Additionally, the notches at the back of the part allow for the use of a 250mm cable tie that can be tightened either around conduit, as shown here, or directly on to the wires if preferred.