Prusa i3 Endstop Holder Z-Axis

thingiverse

This end stop holder for the z axis on my Prusa i3 gives much better reliability.\nI had to replace the clamp type mount in my case after it finally broke, which was a real nuisance (see picture), as it would often malfunction due to miss adjustment and cause failed prints or require recalibration of the leveling of the x axis and the printbed.\nThis end stop holder simply rests on the flanges of the left stepper motor. The end stop PCB is screwed securely in place.\n=> Check out my other Prusa i3 reworks in my collection\nPrint Settings\nPrinter: \n Sintron Prusa i3\n \n Rafts: \n No rafts were used\n \n Supports: \n No supports were needed\n \n Resolution: \n 0.25mm resolution was achieved\n \n Infill: \n 25% infill density was used\n \n Notes: \nThe part was printed upside down as required.