PRUSA I3 - Cover of the connections of the power supply

thingiverse

This Cover has been designed with safety in mind to prevent small hands from touching AC wires while also providing space for a Power Switch and Volt-Amp meter. Most Power Supplies are standardized in size, so this cover should fit most cases due to its versatility. The Cover is fully open at the back and bottom, allowing air to flow freely. I created it specifically for use with my PRUSA I3 3D printer. The original file made with SketchUp is also attached for any necessary adaptations, especially for different accessories. RELEASE NOTE FOR V3: I have not printed this latest version yet as I am waiting for my new Volt-Amp meter to arrive and replace the previous one. However, modifications from the previous version should not cause any issues as they are minor improvements that do not change the fundamental design. If you print it before me, please make it public or let me know if you encounter any problems. V3 List of changes: - Structural reinforcements have been added. - Aesthetic positioning of multiple 3mm holes on each side has allowed for flexible fixation options (one set of M3 bolts and nuts on each side is recommended). - A 2mm hole has been added to the top of the 6.5 mm Power Switch hole, enabling secure positioning. - The sizes of the holes on the facade have been readjusted for better immediate fitting with accessories (25X45mm for the Volt-Amp meter, 8mm for the LED support, and 6.5mm for the Power Switch). - Edges have been smoothened. V4 List of changes: - Thin bars have been added to the design within the bottom openings to assist in printing the edge of the rear-bottom structural reinforcement. - Note that due to this modification, the cover can now be used in various positions of the Power Supply, not just the one shown in the photo.