Prusa Bowden X Carriage - fixed bltouch - 40x40 Noctua

thingiverse

This mount is a reimagined version of Don1337's original design. I was impressed by his work but had some reservations that needed to be addressed. The BLTouch sensor was not properly secured, requiring screws to hold it in place, which resulted in inaccuracies during measurements. Additionally, the standard fan on the Bowden heatsink produced an excessive amount of noise. To rectify this issue, I swapped out the standard fan for a 40x40 model that not only reduced noise but also allowed the heatsink to drop by a few degrees. Fortunately, no additional threads were needed as the M3 screws could be directly screwed into the bracket with ease. Offset BLTouch settings: X: -34 Y: 9