Proximity Sensor Slider

thingiverse

This part enables you to fine-tune the placement of the proximity sensor on the Reach 3D printer. I put it through a test run last night and it works, requiring only three attempts to secure the filament correctly. To assemble this component, use two distinct parts that are printed separately - utilize the wood screw from the original kit to clamp one part onto the sensor. You will need an M3x40mm screw, two M3 nuts, and a washer for successful assembly. Refer to the accompanying photos for step-by-step guidance on how to put everything together. To ensure proper printing, you must flip the Clamp Holder so that its flat surface is positioned on the bed.