Prototyping Board Display Stand (50mm x 70mm)

prusaprinters

Pivoting stand for 50x70mm prototyping board. Has holes for mounting M2 stand-offs.Approximately 180 degrees of rotation. Cable strain relief bracket on right of stand. Pivot point is made from M3 screws and heat set threaded inserts.Be careful when placing the heat set threaded inserts. There isn’t a lot of plastic there and the soldering iron can soften the entire mounting point area if care isn’t taken.This stand can accommodate any project that will fit on a 50 x 70 mm prototyping board.The pictured device is a CO2 monitoring project. It can be used to monitor the CO2 levels in an indoor space such as an office, classroom, workshop, bedroom. See build guide if interested: https://github.com/ZPaulWeleschuk/CO2_Monitor_Arduino Materials needed:2 – M3 x 8mm screws2 – M3 x 4mm heat set threaded inserts Recommended Print Settings: Layer Height: 0.2mm