prototype 1 slide out wallet

thingiverse

I decided to create a wallet, money clip, and card holder from scratch. This initial attempt took just over three hours to print using the settings listed below. In my next prototype, I plan to refine the design by making it slimmer and rounding off the edges. I also intend to increase the size of the sliding holes in order to eliminate the need for a bottom slider. To achieve this, I will remove the rafts and supports and place the slider inside so that the two flanges protrude from the holes. I tested the wallet by inserting three cards and several twenty- and five-dollar bills. The weight of the bills provided enough retention to hold everything in place even when upside down and gently shaken.