Protective Face Shield x 2

thingiverse

This is a remix of the original print: https://www.matterhackers.com/store/l/protective-face-shield/sk/M7LP9Q7M?fbclid=IwAR1KKWhi35VwhQSRfbmSJLaUi22RG2b1GMa5ZEyo430fRQj3XErZOxKjuic To minimize filament usage, I modified the design to reduce the size of the hooks. This modification also simplifies the printing process. Although this change eliminates the benefit of stackability, it seemed like a worthwhile compromise. I redesigned one of the hooks to accommodate two shields side by side. This adjustment not only makes it easier to orient the shield but also adds stability. The print area required for these designs is approximately 200mm x 200mm, leaving plenty of space on my Ender 5 printer. However, in theory, this design can be printed on smaller 3D printers as well. Printing with a 0.8 nozzle, two shields can be produced in under 35 minutes. I used PLA for the fastest possible print time. Further upgrades will be added as soon as possible. Any suggestions for improvement are welcome.