Projector tilting mount

thingiverse

This was designed to support a small projector on the ceiling of an RV. Hardware list: Qty 2 bolts: 7/16" hex head, 1/4-20 x 1-1/2" long. Qty 1, 1/4" flat washer: Place this between the mount body and the knob to reduce friction while tightening. Use one bolt to thread into the round projector mounting surface. It should be a tight fit and thread all the way inside. Then cut off the head of the bolt, leaving about 3/16" exposed. You will need to carefully clean the end of the threads where they were cut. The second bolt holds the parts together and threads into the knob. A photo shows the mount before I added the mounting holes. I was going to use double-sided tape. This could also be used as a camera mount. Updated 9/20/18 I've added some additional mounts for a 1" square bar. The square bar slides into the 1" bar mount bracket. It extends outward from above a cabinet. The projector can mount with either a Ram mount style, or with a snap-on square bar adapter, or with an end cap for a 1" square bar.