Project399 Super G DJI O3 Camera Mount TPU

thingiverse

Please First print the test Cube for the right Flow factor. The test Cube has two holes for M3 Screws, same as the Normal O3 Mount in the Front Standoff position. Make sure M3 Screws sit very snug in these holes, try to mount something to the test Cube like the Topplate with an M3 Screw. if its to lose, adjust the Flow factor in the Slicer, i normally use 105% for Sainsmart but test yourself. Prints should be done in TPU Sainsmart. The Normal Version has no Standoffs in the Front Position like the Apex Mount. You only need 4 M3 Screws drill direct in the Mount. The holes are 8,5mm deep, so maximum 8mm drill in. The 5mm Camera Forward Version of the Mount can use the Standoffs and bring the Camera 5mm to the front. I would recommend testing both and see what you like. For printing, it's not a easy print. The Normal Version i set 3 support Blocker, two one the front bottom holes and in the middle section is no Support Needed. The Forward Version only need the middle support blocker. I recommend Slicer setting for Walls 99, in my opinion gives the print best strenght. Better than say 3 Walls and 100% infill. With 99 Walls the print is only Walls, test this setting with the smaller test Print Cube. Also test the fit of the M3 Screws, should sit very snug like i said, no over drilling with normal force.The Print should be complete Full with 99 Walls, try to rip it appart with tools. If you can rip it appart, adjust printer settings for Walls.