Professional SimpleRTK GNSS Case - Compatible with ArduSimple SimpleRTK2B (v1.0) RTK GPS Board w/ u-blox ZED-F9P

Professional SimpleRTK GNSS Case - Compatible with ArduSimple SimpleRTK2B (v1.0) RTK GPS Board w/ u-blox ZED-F9P

thingiverse

This high-end GNSS enclosure is engineered to be fully compatible with the SimpleRTK2B (v1.0) from ArduSimple, which runs on a u-blox ZED-F9P chip for precise cm-level RTK positioning. The case should fit all three versions of the ArduSimple RTK board, including the version featuring Arduino Headers pre-soldered and the ZigBee long range module version (after removing a pre-scored hole). To ensure robust protection, you will need some M3 (3mm diameter) machine screws. It is highly recommended to use 4 M3x12mm and 3 M3 x 6mm hex machine screws to secure the case lid and board. Before ordering screws, you may want to print and test your board. The top cover is quite snug without the screws, especially if you want easy access to the status LEDs. As a side note, the case was designed to be stack-able and can also stand on its edge to take up less desk space. This enclosure prints most reliably in Carbon Fiber PLA at 0.3um layer height and will print very cleanly at 0.2um height at a reduced print speed. The support material and bridging should be turned off, as long as your print head has a cooling fan. For the maximum protection, it is highly recommended to print solid at 100% in-fill. Over 100 hours and 20+ prototype prints went into making this design with special attention to protect the case from cracking if dropped or crashed from a UAV, so please do not use for commercial purposes without permission. In the near future, check back for a deluxe version of this enclosure that screws onto a professional 5/8" survey pole with integrated magnetic antenna holder and an ultra-light version with tie-down holes for UAVs.

Download Model from thingiverse

With this file you will be able to print Professional SimpleRTK GNSS Case - Compatible with ArduSimple SimpleRTK2B (v1.0) RTK GPS Board w/ u-blox ZED-F9P with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Professional SimpleRTK GNSS Case - Compatible with ArduSimple SimpleRTK2B (v1.0) RTK GPS Board w/ u-blox ZED-F9P.