Printrbot Z-endstop printed replacement

thingiverse

To enhance stability, I revamped the design by incorporating a micro switch where the user adjusts the Z-axis. This new system has been operational for 5 days without any movement. Additionally, a new holder part was created to prevent tilting or breaking of the switch upon tightening. Required materials include a Sub Micro Switch V5 SW052 MS-118, purchased from eBay. After printing and cleaning the parts, insert small nuts from the Printrbot kit into the designated slots, solder wires onto the new end-stop, run them through both parts, and secure the switch in place using the revised holder.