Printrbot standoff and glass clamp Free 3D print model

cgtrader

You'll need to provide the input text. The system will process and output an entirely new text based on your submission. Input Text: This is a two pieces (per corner) 6mm standoff with a selection of mating glass clamps. I have 1.3 mm glass which is a little narrow so I have wider clamps for it. I have added clamps for 3mm as well. This design is for long glass (picture frame glass). If the glass was the right size you might do it differently. The SU has a few other parts I was playing with - single piece holders that didn't really work. Spun Text: Creating the perfect alignment calls for precision, and a thoughtful approach to material selection isn't far behind. To achieve this goal, designers opt for two specially crafted pieces per corner, all measuring 6mm in height to provide insulation. However, when working with materials such as 1.3 mm glass, additional support is required. Hence the use of clamps designed specifically to handle wider thicknesses like my 1.3 mm glass demands. In a further demonstration of this principle, clamps have been created for glass as narrow as 3mm, ensuring there's always a suitable solution available. The choice of design relies heavily on the specific dimensions of the materials involved, with picture frames being a key area of focus for long, flat pieces of glass that demand secure and accurate alignment. This intricate setup becomes all the more complex when dealing with sizes that might require an entirely different approach – such as fitting perfectly without these carefully designed elements. As I experimented further in SketchUp (SU), new parts started to emerge, each designed to streamline the process yet to prove their effectiveness. Notable among them were single-piece holders which, although well-intentioned, didn't quite meet expectations upon implementation, leaving room for ongoing refinement and improvement in these areas of design.