Printrbot Smalls (LE, Limited Edition) Spool Holder

thingiverse

# Printrbot Smalls LE Spool Holder May work on Printrbot Smalls Standard Edition too. An angled spool holder to hold large spools up to nearly a hundred mm wide. Gravity keeps the spools firmly in place, held against the slanted base of the holder while printing. Install it right next to the handle where the spool holder points upwards towards the ceiling. Place your spool of filament so that it rests against the holder's base and tilts away from the printer's Y-carriage metal arm. This holder can hold a minimum spool diameter of about thirty mm. It attaches using two screws, which are slightly longer than the original M3 screws. You might also be able to remove the handle and use the original screws to attach this instead where the handle goes. This Printrbot Smalls LE Spool Holder holds all the 1kg/2.2lb spools I have successfully tested.