Printrbot SImple spring legs

thingiverse

The vibration-limiting legs attach to your Printrbot Simple's front part and fit into its existing screw holes for the XL rear. They offer added stability upfront, rubber feet for non-slip print sessions, and a stylish look. To print these accessories, you need 4 legs, 4 caps, 3 ties, and 1 front attachment. I printed them all at 0.25 with 20% fill, but you can use rubber feet from rod-mounted single hole stoppers or make your own using 3/8" rods. The front springs are secured between a 1/8" aluminum pop-rivet head and a removed head, while I only had enough rivets for four legs, leaving the back ones supported by 1/8" steel rod. If I were to redesign these, I'd lower the tie/pivot point to keep the legs horizontal when not in use.