Printrbot Simple Metal Feet

thingiverse

--Make sure to rotate the file so that the top is on the top before assembling--\nI started printing with my printrbot simple metal shortly after unpacking it, only to notice a considerable amount of noise coming from its operation. After testing several configurations, I discovered that moving it slightly was enough to make it run more smoothly.\nThe resulting design can be seen below:\nPrinting the bottom layers at 10% infill and .25 layer height worked beautifully.\nBy adding some foam pads underneath the printer, the annoying rattling noise caused by vibrations decreased significantly.\nEnjoy your peaceful printing sessions!!!\n\n \n \n Assembly Instructions\nMount the pieces onto the printrbot baseplate as follows: front and back pieces at either side of the plate in the center. Ensure proper fitment for optimal results!\nShare your thoughts and let me know if these work as expected!