Printrbot Printrboard mounting bracket

thingiverse

This creation was crafted in Tinkercad, accessible for editing at https://tinkercad.com/things/dY7R20XRKJ6. It is a mounting bracket designed specifically for a Printrboard (Printrbot's electronics board) to fit onto one of the Printrbot's Z motors. To ensure proper fitting, the tabs and their corresponding slots on the main bracket may necessitate cleaning. I employed 10mm M3 screws to fasten the tabs to the motor; however, your motor might require different screw sizes. Additionally, for attaching the Printrboard to the bracket, I used 3/8 inch #4-40 screws, but 10mm M3 screws may also work effectively. Before proceeding, print the design, test fit and clean up the tabs and slots if necessary, attach the Printrboard to the bracket, slide the tabs into their respective slots, and then securely fasten the tabs onto the motor.