Printrbot LC v1 Replacement Foot

thingiverse

My Printrbot LC v1 has a storied history, marked by the remarkable feat of printing its own repair parts upon arrival from the eBay seller, who shipped it in a nearly empty cardboard box. This correction addresses the last long-standing issue with it: its right foot was completely shattered and unusable to prop up the printer. Since these replacements leave the printer sitting a few millimeters higher than the stock feet, I recommend printing two pairs and replacing both sides to keep the printer level. These parts are also merely press-fit. While they fit snugly enough that I don't expect them to fall off in normal usage, you may want to consider this if you frequently lift your printer off of the table. Designed at 2am using OpenSCAD, sliced with Slic3r, and printed using OctoPrint. Open Source Wins! Print Settings: Printer Brand: Solidoodle Printer: Solidoodle 4 Rafts: No Supports: No Resolution: 0.1976mm Infill: 20% Notes: This design was created to address the slight overextrusion that my SD4 delivers. As such, while a caliper measured the wood thickness at 5.80mm, The 6mm slots in the printed part fit perfectly. Your mileage may vary.