Printrbot LC+ Heated Bed Clips Side & Front

thingiverse

To resolve the issue of an unflat bed on your LC+ printer as it heats up, create four Side Clips and a Front Clip. These clips will help flatten the bed by clamping its edges. To install, slide the clips to the edge of the bed, rotated slightly, then hit the back with a screwdriver to climb onto the bed before pushing them flush and positioning correctly. The Side Clip spines are shallow to avoid Z-Rod assemblies, while the Front Clip is deeper and wider, needing only one. An improved version v2 of these clips has been made, with a 5% reduction on the upper bite for easier installation. Position the forward side clips 65mm back from the front edge of the table and adjust slightly to miss the Z-Rod assemblies. Place the rear side clips equidistant from the hot bed's back edge at around 41.5mm. The Front Clip v2 has also been shaved 5% and corrected for Slic3r compatibility. Remember, trim any leftover flashing before mounting the clips to avoid difficulties during installation.