Printer Front Cover, Ultimaker 3 Extended

thingiverse

Front Panel Design for the Ultimaker 3 Extended. Engineered Specifically for .093” Thick Plexiglas or Lexan Sheets. Optimized Dimensions for Seamless Installation. The Cover Can be Hung on the Side of the Machine When Not in Use. **Required Materials:** 1. Printed Model: Top Plate 2. Printed Model: Top Plate Support 3. Printed Model: Bottom Panel 4. Printed Model: Glass Mounting Pegs 5. Sheet of .093” Thick Plexiglas or Lexan, 11” x 16 5/8” 6. Super Glue (Gel Type Recommended) 7. ¼” Drill Bit with a Small Pilot Drill for Precise Drilling 8. Sandpaper (220 or 320 Grit) for Smoothing Edges **Step-by-Step Assembly Instructions:** 1. Print the top and bottom components. 2. Inspect and sand the parts for a precise fit, if necessary. 3. Cut and drill the Plexiglas/lexan sheet according to the provided diagram. 4. Attach the bottom panel to the glass using super glue, ensuring correct orientation as shown in the image. 5. Assemble and attach the second bottom component to the other side of the glass, following the same orientation guidelines. 6. Glue the top plates together, noting their correct position as depicted in the diagram. 7. Attach the top plates to the glass using the drilled holes for pegs, ensuring a secure fit. 8. Hang the cover over the machine and center it above the opening. 9. Mark the screw locations on the glass for later reference. 10. Drill ¼” holes for clearance of the screws. **Important Design Disclaimer:** The design files provided by Brink Effects are intended solely for your reference. By downloading these files, you acknowledge that you assume responsibility for verifying their suitability and safety for your specific use case. As such, Brink Effects disclaims any liability associated with the use of these files. Please exercise caution when working with sharp edges and keep small objects out of reach from children and pets.