Printed truck V2: Cab

thingiverse

After a string of iterations the vehicle is complete! Once this is connected it's perfectly drivable. Hardware required: 4x M3x25 for attaching baseplate to frame 4x M3x16-30 for attaching baseplate to vehicle 4x M3x10-16 for attaching battery holder to baseplate 2x M3 or equivalent for attaching the on/off switch to baseplate A few cable-ties for securing components to baseplate Some rubber bands to secure battery against battery holder Optional: 2x5mm LED for headlights Suitable resistor or driver for the above You can check out the assembly and drive video for this over at my youtube: http://www.youtube.com/c/MrCrankyfaceProjects You can find the other V2-compatible parts here: Frame: http://www.thingiverse.com/thing:1503418 Rear axle: http://www.thingiverse.com/thing:1470452 Front axle: http://www.thingiverse.com/thing:1460196 Springs: http://www.thingiverse.com/thing:1503424 Gearbox: http://www.thingiverse.com/thing:1392761 Driveshaft: http://www.thingiverse.com/thing:1392796 Rims: http://www.thingiverse.com/thing:1412131 Tyres: http://www.thingiverse.com/thing:1408635 Check me out at: Youtube: http://www.youtube.com/c/MrCrankyfaceProjects Instagram: https://www.instagram.com/mr.crankyface/ 3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface Patreon: http://patreon.com/Mrcrankyface Print Settings: Printer: Custom CoreXY Rafts: No Supports: Yes Resolution: 0.2 Infill: 20% Notes: The baseplate will require support pretty much no matter how you print it, I printed it like it sits on the chassis, with 15% support infill from heatbed and then 10 dense support layers with 70% support infill. The vehicle itself seems to print best upside down with some support for the window frame, I did however not use dense support layers at all here. Print the battery holders on their side for the easiest print.