Printable mini HiFi

thingiverse

Here's my little HiFi project. I must say that I am extremely pleased about this outcome. I initially started this Project to recycle some components that I had on hand, but I didn't anticipate how satisfying it would become. It consists of a Raspberry Pi 3 B, a 7" LCD display, a HifiBerry amplifier, and two 4-ohm full-range speakers. For the software, I installed Volumio because its interface is very clean and easy to set up. I printed everything entirely on my Anycubic i3 Mega. For the white components, I used Sunlu PLA+, which has a matte finish and a pleasant soft touch after sanding. For the black components, I used ALFAOMNIA by Filoalfa - it's a PETG loaded with carbon fiber that prints out perfectly without any post-production work. It took many hours of printing and some design problems to overcome, but overall, it's not bad and sounds good too. If you enjoyed this project and want to show your appreciation, consider supporting me by sending a tip on Thingiverse or my PayPal here.