Printable Fidget Cube

thingiverse

This is my version of a printable fidget Cube that's fully printable, excluding the five buttons. Full credit for the Fidget Cube idea goes to Antsy Labs (https://www.antsylabs.com/), who ran a very successful Kickstarter campaign. My design is loosely based on the real Fidget Cube and borrows other design ideas from similar designs uploaded here on Thingiverse. Required Items A set of printed parts (See HowTo) Four 6 x 6 x 5mm tact switches like these: https://goo.gl/QX8TDc One 8.5 x 8.5mm latching push button like these: https://goo.gl/PLje5V Glue suitable for your filament of choice HowTo Print each of the three files with 20% infill, no support, and "things" (Buttons, wheel, etc.) with 50% infill, no support. Clean prints as best as possible by filing, sanding, etc. This is important because there are some pretty steep overhangs in this design. Insert switches and buttons into their respective holes and cover with printed buttons. Most probably you need to remove the pins/contacts from your buttons to make them fit. Use a piece of 1.75mm filament as an axle for the gear wheels. Push through from maze side to rocker-switch side of the cube. Push in the printed rocker switch. Insert sliding knob into maze by pulling the maze cap slightly upwards. If all goes well, test and break in all moving parts until they move freely. You should then glue the six caps on to keep them in place. Be careful not to glue any buttons/sliders in place permanently! Have fun!