Print-in-Place Slim Wallet

thingiverse

A 5-card capacity slim wallet with ejector tab. I designed this from scratch, but the inspiration for the stepped lever mechanism was taken from [this design.](https://www.thingiverse.com/thing:4072298) Wallet is functional at any reasonable layer height, but because of the thinness of the walls at some points, my slicer had minor surface defects with this model at .2 mm and above. I tested at 0.15 mm and this problem was completely resolved. In some of my early designs, cards would go flying if they were ejected too vigorously. After dozens of revisions and a good deal of testing, I am confident that this design is robust. However, I will not accept responsibility if any cards are accidentally lost when deployed.