Print Bed Cleaner

thingiverse

I use BuildTak on my CR-20 and also rely on hairspray to achieve superior adhesion. However, this surface often becomes cluttered and extremely challenging to properly clean. I've discovered that the hairspray accumulates over time, causing undesirable artefacts to appear on prints. This print will consume approximately 50g of filament when set at a 0.2 layer height with 20% infill. Print at a relatively high temperature, ensuring a tightly levelled bed. Allow it to cool slightly... It will then yield a smooth surface for peeling off your BuildTak surface, taking with it many of the clumps and artifacts that have been left on the bed.